Impey Waterguard Wall Membrane

Impey Waterguard is the next generation of wetroom waterproofing systems. It provides a faster and easier method of tanking a leak-free wet floor area.

• Co-Polymer membrane with a butyl rubber backing creates a
completely watertight barrier
• Polypropylene surface provides a key for the tile adhesive
• Can be used with epoxy grout and solvent based sealers for
stone tiles
• Self adhesive and supplied on a roll for easy application
• No curing time to enable faster installation

Self adhesive on one side
Waterguard has a butyl rubber adhesive on one side only and a co-polymer surface on the other. This makes installation much easier as the installer can work on the membrane without getting stuck.

Superior waterproofing capabilities
Tests have proven that Waterguard provides superior waterproofing capabilities to Tilesafe. The test was conducted with a 150mm head of water over a series of weeks. No leak from Waterguard.

Excellent crack bridging properties
Tests have shown that Waterguard has superior lateral movement (5mm)
absorbtion properties caused by the shifting and drying of floors over time.

Not sensitive to chemicals
Can be used with epoxy grout and solvent based sealers for stone  tiles - unlike Tilesafe. 

Supplied with a butyl sealant
Part of the pack, so no need for the installer to purchase separately. Can also be used to repair small holes in the membrane, if damaged.

Guide lines for easy measurement
Pre-printed grid lines provide an accurate guide when trimming the membrane.

Supplied with 150mm wide jointing tape.
Waterguard cannot be overlapped, so a jointing tape is supplied to create a watertight seal at any joints.

Kits available in 10m 
Options to suit most bathroom sizes.

Waterguard kits contain:
5m square or 10m square (depending on choice) of Impey Waterguard membrane, plus

• 500ml BAL primer
• 15m jointing tape
• Butyl sealant